MOMTAJ RUBBER INDUSTRIES
UNIT-1:
Vill: Shibramchawk,Po: Panchla, Dist: Howrah,Pin:711322,City:Kolkata,State:West Bengal,India.
UNIT-2:
Vill: Santoshpur,Po: Santoshpur, Dist: Howrah,Pin:711310,City:Kolkata,State:West Bengal,India.
OFFICE :
Vill: Paramanandachawk,Po: Santoshpur,Dist:Howrah.Pin:711310,City-Kolkata,State:West Bengal,India.
Contact Persons:
Sales Depertment
Phone: 7595804527
Mr. Sekh. Meheraj Ali (HOD)
Phone: +91-9062875314
Email: info@momtajrubber.com
Expansion joints are a crucial component to an industrial piping system, allowing for movement caused by thermal expansion and equipment vibration. This expansion and vibration can be detrimental to the integrity of the machines and nearby equipment. This movement can also increase the risk of failure. Protecting your piping investment with proper installation of expansion joints is a reliable way to prevent failures and unnecessary down time.
Features and Benefits
Triple arch expansion joints are also available for greater movement and reduced spring rates. We can also manufacture Concentric and Eccentric Tapers and Offset styles. Sizes up to 144” can be constructed.
Standard control rods that install out-board of the mating flanges are standard. Integral tie rods attached to the floating flanges can also be supplied.
NOTE: Decrease of working pressure for constructions made of Kevlar® above 350°F.
After the initial installation, we recommend checking the torque of each bolt after 24 hours have elapsed or a temperature cycle or pressure cycle (hydrostatic test) has occurred. Any bolts falling below the recommended value should be retorqued. Values should only be exceeded by 10% increments when necessary to reseal. All torquing on the process system should be done when the system is ambient and cool.
Retourquing should be performed annually, especially if the system experiences elevated temperatures or extreme temperature swings.
In order to accommodate a wide array of temperatures, MOMTAJ is available in an assortment of elastomer and reinforcement combinations. Temperature allowances may range from 180°F to 400°F.